|
STM32L486xx HAL User Manual
|
Defines | |
| #define | TIM_TRGO_RESET 0x00000000U |
| #define | TIM_TRGO_ENABLE TIM_CR2_MMS_0 |
| #define | TIM_TRGO_UPDATE TIM_CR2_MMS_1 |
| #define | TIM_TRGO_OC1 (TIM_CR2_MMS_1 | TIM_CR2_MMS_0) |
| #define | TIM_TRGO_OC1REF TIM_CR2_MMS_2 |
| #define | TIM_TRGO_OC2REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_0) |
| #define | TIM_TRGO_OC3REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_1) |
| #define | TIM_TRGO_OC4REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_1 | TIM_CR2_MMS_0) |
| #define TIM_TRGO_ENABLE TIM_CR2_MMS_0 |
TIMx_CR1.CEN bit is used as trigger output (TRGO)
Definition at line 883 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_OC1 (TIM_CR2_MMS_1 | TIM_CR2_MMS_0) |
Capture or a compare match 1 is used as trigger output (TRGO)
Definition at line 885 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_OC1REF TIM_CR2_MMS_2 |
OC1REF signal is used as trigger output (TRGO)
Definition at line 886 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_OC2REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_0) |
OC2REF signal is used as trigger output(TRGO)
Definition at line 887 of file stm32l4xx_hal_tim.h.
Referenced by HAL_TIMEx_HallSensor_Init().
| #define TIM_TRGO_OC3REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_1) |
OC3REF signal is used as trigger output(TRGO)
Definition at line 888 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_OC4REF (TIM_CR2_MMS_2 | TIM_CR2_MMS_1 | TIM_CR2_MMS_0) |
OC4REF signal is used as trigger output(TRGO)
Definition at line 889 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_RESET 0x00000000U |
TIMx_EGR.UG bit is used as trigger output (TRGO)
Definition at line 882 of file stm32l4xx_hal_tim.h.
| #define TIM_TRGO_UPDATE TIM_CR2_MMS_1 |
Update event is used as trigger output (TRGO)
Definition at line 884 of file stm32l4xx_hal_tim.h.
1.7.6.1