You should execute simseny.exe, next testsimseny.exe (see Figure 10, “Test program of the simulator.”). If everything goes, the simulator works properly.

Figure 10. Test program of the simulator.

Comment out code line where simseny_9112.h header file is included.

If program compiles, the problem could be that the header file is in a mistaken place. Verify the corresponding section.

If the program doesn't compile, the problem doesn't have relation with the simulator.

The installation has not been installed properly. Reinstall it.

Check that all the card functions are in a single module.

Limit the timers speed to 500 milliseconds.