PLL Configuration

Defines
#define	__HAL_RCC_PLL_ENABLE()   (*(__IO uint32_t *) RCC_CR_PLLON_BB = ENABLE)
	Macros to enable or disable the main PLL.
#define	__HAL_RCC_PLL_DISABLE()   (*(__IO uint32_t *) RCC_CR_PLLON_BB = DISABLE)
#define	__HAL_RCC_PLL_PLLSOURCE_CONFIG(__PLLSOURCE__)   MODIFY_REG(RCC->PLLCFGR, RCC_PLLCFGR_PLLSRC, (__PLLSOURCE__))
	Macro to configure the PLL clock source.
#define	__HAL_RCC_PLL_PLLM_CONFIG(__PLLM__)   MODIFY_REG(RCC->PLLCFGR, RCC_PLLCFGR_PLLM, (__PLLM__))
	Macro to configure the PLL multiplication factor.

---

Define Documentation

#define __HAL_RCC_PLL_DISABLE

(

)

(*(__IO uint32_t *) RCC_CR_PLLON_BB = DISABLE)

Definition at line 1054 of file stm32f4xx_hal_rcc.h.

Referenced by HAL_PWREx_ControlVoltageScaling(), and HAL_RCC_OscConfig().

#define __HAL_RCC_PLL_ENABLE

(

)

(*(__IO uint32_t *) RCC_CR_PLLON_BB = ENABLE)

Macros to enable or disable the main PLL.

Note:

After enabling the main PLL, the application software should wait on PLLRDY flag to be set indicating that PLL clock is stable and can be used as system clock source.

The main PLL can not be disabled if it is used as system clock source

The main PLL is disabled by hardware when entering STOP and STANDBY modes.

Definition at line 1053 of file stm32f4xx_hal_rcc.h.

Referenced by HAL_PWREx_ControlVoltageScaling(), and HAL_RCC_OscConfig().

#define __HAL_RCC_PLL_PLLM_CONFIG

(

__PLLM__

)

MODIFY_REG(RCC->PLLCFGR, RCC_PLLCFGR_PLLM, (__PLLM__))

Macro to configure the PLL multiplication factor.

Note:

This function must be used only when the main PLL is disabled.

Parameters:

__PLLM__

specifies the division factor for PLL VCO input clock This parameter must be a number between Min_Data = 2 and Max_Data = 63.

Note:

You have to set the PLLM parameter correctly to ensure that the VCO input frequency ranges from 1 to 2 MHz. It is recommended to select a frequency of 2 MHz to limit PLL jitter.

Definition at line 1075 of file stm32f4xx_hal_rcc.h.

#define __HAL_RCC_PLL_PLLSOURCE_CONFIG

(

__PLLSOURCE__

)

MODIFY_REG(RCC->PLLCFGR, RCC_PLLCFGR_PLLSRC, (__PLLSOURCE__))

Macro to configure the PLL clock source.

Note:

This function must be used only when the main PLL is disabled.

Parameters:

__PLLSOURCE__

specifies the PLL entry clock source. This parameter can be one of the following values: RCC_PLLSOURCE_HSI: HSI oscillator clock selected as PLL clock entry RCC_PLLSOURCE_HSE: HSE oscillator clock selected as PLL clock entry

Definition at line 1064 of file stm32f4xx_hal_rcc.h.