CAN init structure definition. More...
#include <stm32f4xx_can.h>
Data Fields | |
| uint16_t | CAN_Prescaler |
| uint8_t | CAN_Mode |
| uint8_t | CAN_SJW |
| uint8_t | CAN_BS1 |
| uint8_t | CAN_BS2 |
| FunctionalState | CAN_TTCM |
| FunctionalState | CAN_ABOM |
| FunctionalState | CAN_AWUM |
| FunctionalState | CAN_NART |
| FunctionalState | CAN_RFLM |
| FunctionalState | CAN_TXFP |
CAN init structure definition.
| FunctionalState CAN_ABOM |
Enable or disable the automatic bus-off management. This parameter can be set either to ENABLE or DISABLE.
| FunctionalState CAN_AWUM |
Enable or disable the automatic wake-up mode. This parameter can be set either to ENABLE or DISABLE.
| uint8_t CAN_BS1 |
Specifies the number of time quanta in Bit Segment 1. This parameter can be a value of CAN_time_quantum_in_bit_segment_1
| uint8_t CAN_BS2 |
Specifies the number of time quanta in Bit Segment 2. This parameter can be a value of CAN_time_quantum_in_bit_segment_2
| uint8_t CAN_Mode |
Specifies the CAN operating mode. This parameter can be a value of CAN_operating_mode
| FunctionalState CAN_NART |
Enable or disable the non-automatic retransmission mode. This parameter can be set either to ENABLE or DISABLE.
| uint16_t CAN_Prescaler |
Specifies the length of a time quantum. It ranges from 1 to 1024.
| FunctionalState CAN_RFLM |
Enable or disable the Receive FIFO Locked mode. This parameter can be set either to ENABLE or DISABLE.
| uint8_t CAN_SJW |
Specifies the maximum number of time quanta the CAN hardware is allowed to lengthen or shorten a bit to perform resynchronization. This parameter can be a value of CAN_synchronisation_jump_width
| FunctionalState CAN_TTCM |
Enable or disable the time triggered communication mode. This parameter can be set either to ENABLE or DISABLE.
| FunctionalState CAN_TXFP |
Enable or disable the transmit FIFO priority. This parameter can be set either to ENABLE or DISABLE.
1.6.3