|
STM32F439xx HAL User Manual
|
Header file of PWR LL module. More...
#include "stm32f4xx.h"Go to the source code of this file.
Defines | |
| #define | LL_PWR_CR_CSBF PWR_CR_CSBF |
| #define | LL_PWR_CR_CWUF PWR_CR_CWUF |
| #define | LL_PWR_CSR_WUF PWR_CSR_WUF |
| #define | LL_PWR_CSR_SBF PWR_CSR_SBF |
| #define | LL_PWR_CSR_PVDO PWR_CSR_PVDO |
| #define | LL_PWR_CSR_VOS PWR_CSR_VOSRDY |
| #define | LL_PWR_CSR_EWUP1 PWR_CSR_EWUP |
| #define | LL_PWR_REGU_VOLTAGE_SCALE3 (PWR_CR_VOS_0) |
| #define | LL_PWR_REGU_VOLTAGE_SCALE2 (PWR_CR_VOS_1) |
| #define | LL_PWR_REGU_VOLTAGE_SCALE1 (PWR_CR_VOS_0 | PWR_CR_VOS_1) /* The SCALE1 is not available for STM32F401xx devices */ |
| #define | LL_PWR_MODE_STOP_MAINREGU 0x00000000U |
| #define | LL_PWR_MODE_STOP_LPREGU (PWR_CR_LPDS) |
| #define | LL_PWR_MODE_STOP_MAINREGU_UNDERDRIVE (PWR_CR_MRUDS | PWR_CR_FPDS) |
| #define | LL_PWR_MODE_STOP_LPREGU_UNDERDRIVE (PWR_CR_LPDS | PWR_CR_LPUDS | PWR_CR_FPDS) |
| #define | LL_PWR_MODE_STOP_MAINREGU_DEEPSLEEP (PWR_CR_MRLVDS | PWR_CR_FPDS) |
| #define | LL_PWR_MODE_STOP_LPREGU_DEEPSLEEP (PWR_CR_LPDS | PWR_CR_LPLVDS | PWR_CR_FPDS) |
| #define | LL_PWR_MODE_STANDBY (PWR_CR_PDDS) |
| #define | LL_PWR_REGU_DSMODE_MAIN 0x00000000U |
| #define | LL_PWR_REGU_DSMODE_LOW_POWER (PWR_CR_LPDS) |
| #define | LL_PWR_PVDLEVEL_0 (PWR_CR_PLS_LEV0) |
| #define | LL_PWR_PVDLEVEL_1 (PWR_CR_PLS_LEV1) |
| #define | LL_PWR_PVDLEVEL_2 (PWR_CR_PLS_LEV2) |
| #define | LL_PWR_PVDLEVEL_3 (PWR_CR_PLS_LEV3) |
| #define | LL_PWR_PVDLEVEL_4 (PWR_CR_PLS_LEV4) |
| #define | LL_PWR_PVDLEVEL_5 (PWR_CR_PLS_LEV5) |
| #define | LL_PWR_PVDLEVEL_6 (PWR_CR_PLS_LEV6) |
| #define | LL_PWR_PVDLEVEL_7 (PWR_CR_PLS_LEV7) |
| #define | LL_PWR_WAKEUP_PIN1 (PWR_CSR_EWUP) |
| #define | LL_PWR_WriteReg(__REG__, __VALUE__) WRITE_REG(PWR->__REG__, (__VALUE__)) |
| Write a value in PWR register. | |
| #define | LL_PWR_ReadReg(__REG__) READ_REG(PWR->__REG__) |
| Read a value in PWR register. | |
Functions | |
| __STATIC_INLINE void | LL_PWR_EnableUnderDriveMode (void) |
| Enable Under Drive Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableUnderDriveMode (void) |
| Disable Under Drive Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledUnderDriveMode (void) |
| Check if Under Drive Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableOverDriveSwitching (void) |
| Enable Over drive switching. | |
| __STATIC_INLINE void | LL_PWR_DisableOverDriveSwitching (void) |
| Disable Over drive switching. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledOverDriveSwitching (void) |
| Check if Over drive switching is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableOverDriveMode (void) |
| Enable Over drive Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableOverDriveMode (void) |
| Disable Over drive Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledOverDriveMode (void) |
| Check if Over drive switching is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableMainRegulatorDeepSleepUDMode (void) |
| Enable Main Regulator in deepsleep under-drive Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableMainRegulatorDeepSleepUDMode (void) |
| Disable Main Regulator in deepsleep under-drive Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledMainRegulatorDeepSleepUDMode (void) |
| Check if Main Regulator in deepsleep under-drive Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableLowPowerRegulatorDeepSleepUDMode (void) |
| Enable Low Power Regulator in deepsleep under-drive Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableLowPowerRegulatorDeepSleepUDMode (void) |
| Disable Low Power Regulator in deepsleep under-drive Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledLowPowerRegulatorDeepSleepUDMode (void) |
| Check if Low Power Regulator in deepsleep under-drive Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableMainRegulatorLowVoltageMode (void) |
| Enable Main Regulator low voltage Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableMainRegulatorLowVoltageMode (void) |
| Disable Main Regulator low voltage Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledMainRegulatorLowVoltageMode (void) |
| Check if Main Regulator low voltage Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableLowPowerRegulatorLowVoltageMode (void) |
| Enable Low Power Regulator low voltage Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableLowPowerRegulatorLowVoltageMode (void) |
| Disable Low Power Regulator low voltage Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledLowPowerRegulatorLowVoltageMode (void) |
| Check if Low Power Regulator low voltage Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_SetRegulVoltageScaling (uint32_t VoltageScaling) |
| Set the main internal Regulator output voltage. | |
| __STATIC_INLINE uint32_t | LL_PWR_GetRegulVoltageScaling (void) |
| Get the main internal Regulator output voltage. | |
| __STATIC_INLINE void | LL_PWR_EnableFlashPowerDown (void) |
| Enable the Flash Power Down in Stop Mode. | |
| __STATIC_INLINE void | LL_PWR_DisableFlashPowerDown (void) |
| Disable the Flash Power Down in Stop Mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledFlashPowerDown (void) |
| Check if the Flash Power Down in Stop Mode is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableBkUpAccess (void) |
| Enable access to the backup domain. | |
| __STATIC_INLINE void | LL_PWR_DisableBkUpAccess (void) |
| Disable access to the backup domain. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledBkUpAccess (void) |
| Check if the backup domain is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableBkUpRegulator (void) |
| Enable the backup Regulator. | |
| __STATIC_INLINE void | LL_PWR_DisableBkUpRegulator (void) |
| Disable the backup Regulator. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledBkUpRegulator (void) |
| Check if the backup Regulator is enabled. | |
| __STATIC_INLINE void | LL_PWR_SetRegulModeDS (uint32_t RegulMode) |
| Set voltage Regulator mode during deep sleep mode. | |
| __STATIC_INLINE uint32_t | LL_PWR_GetRegulModeDS (void) |
| Get voltage Regulator mode during deep sleep mode. | |
| __STATIC_INLINE void | LL_PWR_SetPowerMode (uint32_t PDMode) |
| Set Power Down mode when CPU enters deepsleep. | |
| __STATIC_INLINE uint32_t | LL_PWR_GetPowerMode (void) |
| Get Power Down mode when CPU enters deepsleep. | |
| __STATIC_INLINE void | LL_PWR_SetPVDLevel (uint32_t PVDLevel) |
| Configure the voltage threshold detected by the Power Voltage Detector. | |
| __STATIC_INLINE uint32_t | LL_PWR_GetPVDLevel (void) |
| Get the voltage threshold detection. | |
| __STATIC_INLINE void | LL_PWR_EnablePVD (void) |
| Enable Power Voltage Detector. | |
| __STATIC_INLINE void | LL_PWR_DisablePVD (void) |
| Disable Power Voltage Detector. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledPVD (void) |
| Check if Power Voltage Detector is enabled. | |
| __STATIC_INLINE void | LL_PWR_EnableWakeUpPin (uint32_t WakeUpPin) |
| Enable the WakeUp PINx functionality. | |
| __STATIC_INLINE void | LL_PWR_DisableWakeUpPin (uint32_t WakeUpPin) |
| Disable the WakeUp PINx functionality. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsEnabledWakeUpPin (uint32_t WakeUpPin) |
| Check if the WakeUp PINx functionality is enabled. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_WU (void) |
| Get Wake-up Flag. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_SB (void) |
| Get Standby Flag. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_BRR (void) |
| Get Backup Regulator ready Flag. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_PVDO (void) |
| Indicate whether VDD voltage is below the selected PVD threshold. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_VOS (void) |
| Indicate whether the Regulator is ready in the selected voltage range or if its output voltage is still changing to the required voltage level. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_OD (void) |
| Indicate whether the Over-Drive mode is ready or not. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_ODSW (void) |
| Indicate whether the Over-Drive mode switching is ready or not. | |
| __STATIC_INLINE uint32_t | LL_PWR_IsActiveFlag_UD (void) |
| Indicate whether the Under-Drive mode is ready or not. | |
| __STATIC_INLINE void | LL_PWR_ClearFlag_SB (void) |
| Clear Standby Flag. | |
| __STATIC_INLINE void | LL_PWR_ClearFlag_WU (void) |
| Clear Wake-up Flags. | |
| __STATIC_INLINE void | LL_PWR_ClearFlag_UD (void) |
| Clear Under-Drive ready Flag. | |
| ErrorStatus | LL_PWR_DeInit (void) |
| De-initialize the PWR registers to their default reset values. | |
Header file of PWR LL module.
Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. 2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. 3. Neither the name of STMicroelectronics nor the names of its contributors may be used to endorse or promote products derived from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
Definition in file stm32f4xx_ll_pwr.h.
1.7.6.1