STM32F439xx HAL User Manual
Defines
LSE Configuration
RCC Exported Macros

Defines

#define __HAL_RCC_LSE_CONFIG(__STATE__)
 Macro to configure the External Low Speed oscillator (LSE).

Define Documentation

#define __HAL_RCC_LSE_CONFIG (   __STATE__)
Value:
do {                                       \
                      if((__STATE__) == RCC_LSE_ON)            \
                      {                                        \
                        SET_BIT(RCC->BDCR, RCC_BDCR_LSEON);    \
                      }                                        \
                      else if((__STATE__) == RCC_LSE_BYPASS)   \
                      {                                        \
                        SET_BIT(RCC->BDCR, RCC_BDCR_LSEBYP);   \
                        SET_BIT(RCC->BDCR, RCC_BDCR_LSEON);    \
                      }                                        \
                      else                                     \
                      {                                        \
                        CLEAR_BIT(RCC->BDCR, RCC_BDCR_LSEON);  \
                        CLEAR_BIT(RCC->BDCR, RCC_BDCR_LSEBYP); \
                      }                                        \
                    } while(0U)

Macro to configure the External Low Speed oscillator (LSE).

Note:
Transition LSE Bypass to LSE On and LSE On to LSE Bypass are not supported by this macro. User should request a transition to LSE Off first and then LSE On or LSE Bypass.
As the LSE is in the Backup domain and write access is denied to this domain after reset, you have to enable write access using HAL_PWR_EnableBkUpAccess() function before to configure the LSE (to be done once after reset).
After enabling the LSE (RCC_LSE_ON or RCC_LSE_BYPASS), the application software should wait on LSERDY flag to be set indicating that LSE clock is stable and can be used to clock the RTC.
Parameters:
__STATE__specifies the new state of the LSE. This parameter can be one of the following values:
  • RCC_LSE_OFF: turn OFF the LSE oscillator, LSERDY flag goes low after 6 LSE oscillator clock cycles.
  • RCC_LSE_ON: turn ON the LSE oscillator.
  • RCC_LSE_BYPASS: LSE oscillator bypassed with external clock.

Definition at line 954 of file stm32f4xx_hal_rcc.h.

Referenced by HAL_RCC_OscConfig().